Bullfight Cushion Trampoline
Inflatable castle is an air filled entertainment facility with Castle characteristics. It is made of PVC fabric with friendly and soft environment. In the sealed state, the product is maintained by continuous supply of blowers. Provide happiness for children. Because of its lovely and unique shape, it is loved by children. Also known as: inflatable castle, children's castle, inflatable trampoline, inflatable slide, children's Park and so on.
Bullfight cushion trampoline
This product is suitable for park, community square, city square, tourist attractions, shopping malls, department stores and other investment and operation, low cost and high return, is a good project for your small venture capital. According to our customers'reaction, an inflatable castle usually has an income of nearly 500 yuan a day. If it is put in a good place, it has an income of nearly 1000 yuan a day. As soon as the market was launched, there was a lot of excitement.
Exquisite workmanship, strict requirements
1. Dirty: Finished product surface is bright, do not allow dirt on the surface, such as: footprints, ballpoint pen lines, dust, glue marks, etc.
2. deformation: deviate from the original shape and size. The difference between the deviations is less than 1cm.
3. burrs: the highest and lowest positions in cutting should not exceed 1.5mm in 30cm.
4. scratch: the surface of the finished product should not be scratched.
5. warpage: the horizontal or vertical deviation between the front and rear parts of the product is not greater than 5cm within 3 meters.
6. the interface and seal are uneven: the 90cm2 prominence and normal vertical height are not higher than 0.5cm.
7. wrinkle: the difference between 1 meters is controlled in 0.5cm.
8. screen printing: the printing is clear and the edges are not blurred.
9. splice position: the difference of splicing edge is controlled at 1.0mm outside 1.2mm of wheel rim.
10. color: the difference of color of the same color material is not obvious difference at 2 meters.
11. rubber edge protrusion: the right and left position of splicing should be controlled at 0.5mm and should not be used before and after.
12. surface: the finished product standard summarized above. Due to the reasons of display, photo and other reasons, the product may have fine color difference.
Welcome to call for consultation or customization.